MIDWESTWHEEL.COM MEMBER KANSAS CITY 5801 E. Front St. Main ....(816) 471-1552 Parts....(800) 821-7402 JOPLIN 2424 Stephens Blvd. Main ....(417) 717-6022 Parts....(866) 318-9111 SPRINGFIELD 812 Lillian Dr. ∙ Strafford, MO Main ....(417) 429-2476 Parts....(800) 785-3705 SIOUX CITY 1819 4th St. Main ....(712) 252-7969 Parts....(800) 943-3534 CEDAR RAPIDS 200 50th Ave. S.W. Main ....(319) 365-4453 Parts....(800) 332-5435 DES MOINES 1436 E. Ovid Ave. Main ....(515) 265-1491 Parts....(800) 888-0248 CLEAR LAKE 840 Hwy. 18 W. Main ....(641) 357-7101 Parts....(800) 397-5630 DAVENPORT 8502 Northwest Blvd. Main ....(563) 322-2671 Parts....(800) 553-1886 OMAHA 9770 S 142nd Street, Suite 1 Main ....(531) 239-3050 Parts....(800) 322-8757 NEBRASKA IOWA MISSOURI January 7, 2025 (33TRW Reman Steering Gears and Power Steering Pumps NP) 3C REMOTE FILL CANISTERS ONLY Drain all fluid from canister assembly Remove filter element in canister assembly Clean and inspect canister Install new replacement filter assembly into canister 4 PULLEY TYPE PUMPS ONLY Re-install pulley assembly onto pump assembly 5 INSTALL PUMP ASSEMBLY 5A DIRECT DRIVE PUMPS Remove all dirt & oil from the engine external pump mounting surface prior to re-installation Install pump assembly with correct gearing set-up or coupler and correct gasket or o-ring mounting seal. 5B PULLEY DRIVE PUMPS Clean inspect brackets for damage or wear Re-mount pump into bracket assembly correctly Re-install fan belts Do not over tighten fan belts 6 FLUSHING THE STEERING SYSTEM Connect the bypass/hose (pump to tank) if used in application Connect psi outlet hose from pump to gear assembly Position return/feed hose from gear box going to pump or canister into a suitable container Plug return opening at canister to prevent drainage Fill and maintain fluid level in canister with new fluid only Have vehicle front end tires unloaded (lift front end off the ground) Steering vehicle front end from axle stop to axle stop (engine shut off) Maintain oil level in canister at all times Crank over vehicle engine without starting to induce steering fluid into hydraulic system Maintain oil level in canister at all times Steering vehicle front end from axle stop to axle stop with engine off Repeat procedure until fluid runs clean from return line. Reconnect return line gear to pump assembly or canister 7 Check fluid levels and steer vehicle front end axle stop to axle stop with engine running unloaded 8 Load steering axle on floor and steer from axle stop to axle stop with engine running 9 BLEED STEERING SYSTEM AS PER MANUFACTURES SPECIFICATIONS 10 Check and fill fluid levels to manufacturer specifications IMPORTANT! Power Steering Pump Installation Procedure, Continued FAILURE TO FOLLOW THESE INSTALLATION PROCEDURES CAN VOID THE WARRANTY
RkJQdWJsaXNoZXIy MTEyNjY3NA==