CLUTCH ADJUSTER MC 125489 Kwik Adjuster TOOLS TRUCK CLUTCH & FLYWHEEL HANDLER - LOW CLEARANCE OT 5018A Flywheel Handling Attachment for Clutch Handler - OT 516160 • Replaces 14” & 15-1/2” clutch assemblies weighing up to 250 lbs. • 13” low point enables access below side faring. • Linkage raises load from horizontal to vertical position. • 360 degree swivel head. • Includes a 2” spline shaft with a 1-1/4”pilot to aid alignment. • Covered by OTC Lifetime Warranty®. CLUTCH ADJUSTING WRENCH OT 7028 CLUTCH ADJUSTMENT GAUGE SET OT 5035 OT 7075 2,200 LB. CAPACITY LOW-LIFT TRANSMISSION JACK OT 5019A • Special mounting adapter fits popular Eaton® Fuller® RoadRanger® transmissions used on nearly all Class 7 and 8 heavy-duty trucks. Mounting plate angle is adjusted with the turn of a wrench. • Swiveling pump handle permits ease of operation in restricted working spaces. Fast-acting pump quickly raises lifting arm. • Includes No. 504231 adapter for Eaton® Fuller® RoadRanger® transmissions (also available separately). CLUTCH ALIGNING SHAFTS MC AT-150 1-1/2" Od Alignment Tool MC AT175 1-3/4" Od, 1-1/4" Pilot, 7.375" MC AT175X1 1-3/4" Od, 1" Pilot. MC AT-200-10 2" Od, 1-1/4" Pilot, 10 Spline, 7.3" Long MC AT-200-14 2" Shaft 14 Spline Clutc H Alignment Tool MC AT-200-18 Align Tool 2" 18 Spline MC AT-200-18HD Align Tool 2" 18 Spline 1.181" MC AT-200-24 Tool For Max104461-1 Clu Tch 2 INCH BEARING DRIVER OT 5066 This tool is designed to install the bearing on 2” diameter input shafts used in Eaton® Fuller® Roadranger® transmissions. OT 7070A SELF-ADJUSTING CLUTCH ROTATING TOOL OT 5044 This handy tool replaces the self-adjuster mechanism on Spicer self-adjusting clutches, allowing you to manually adjust them with a wrench or socket. • 3/4" hex drive. BUSHING GREASE TOOL - CLUTCH MC GT1 CLUTCH ADJUSTMENT TOOL MC MAXCAT1 TRUCK TRANSMISSION BEARING SERVICE SET Designed to help you remove input shaft bearings and countershaft bearings, in both the main and auxiliary boxes of heavy-duty Fuller transmissions. It will also remove end yokes from 1600/16101810 series transmissions. The puller delivers 10 tons of mechanical power- essential force for working on big gearboxes. Works on Fuller twin-countershaft transmissions: 125, 600, 660, 900, 9500, 1100, 12500, 12600, 13000, 14600, 15600, and 8600 series, 910-913, 915, and 9513. OT 7070A Truck transmission bearing service set OT 7075 Transmission output shaft end yoke remover only
RkJQdWJsaXNoZXIy MTEyNjY3NA==