06Continental Crimper Machine Lubrication Tech Tip1300010320

MIDWESTWHEEL.COM IOWA MISSOURI DES MOINES 1436 E. Ovid Ave. office 515.265.1491 fax 515.265.4120 parts fax 800.314.4329 parts 800.888.0248 CEDAR RAPIDS 200 50th Ave. S.W. main 319.365.4453 fax 319.365.6327 parts fax 877.706.6085 parts 800.332.5435 DAVENPORT 8502 Northwest Blvd. main 563.322.2671 fax 563.322.5940 parts 800.553.1886 SIOUX CITY 1819 E. 4th St. main 712.252.7969 fax 712.252.6149 parts 800.943.3534 CLEAR LAKE 840 Hwy. 18 W. main 641.357.7101 fax 641.357.8190 parts fax 800.548.9674 parts 800.397.5630 KANSAS CITY 5801 E. Front St. main 816.471.1552 fax 816.471.0813 parts 800.821.7402 TRUCK PARTS SUPER STORE TM Tech Tip Hydraulics Legal Notice The content of this publication is not legally binding and is rovided as information only. The trademarks displayed in this publication are the property of Continental AG and/or its affiliates. Copyright © 2016 ContiTech AG. All rights reserved. For complete information go to: www.contitech.de/discl_en www.contitech.us U.S.A. and Canada 1-800-869-043 FAX 1-800-228-3148 Canada (French only) 1-888-275-4397 FAX 1-888-464-4397 Mexico (Within Mexico) 01-800-439-7373 (Outside Mexico) +52-444-834-5803 Contact ContiTech North America Veyance Technologies, Inc. 703 S. Cleveland Massillon Road Fairlawn, OH 44333-3023 U.S.A. PC125-RCD Lubrication Tech Tip The PC125-RCD portable crimper is designed for higher production volume and repetitive use with its open design, removable pusher and easy-to-use, spring-loaded die set. In order to maintain its high performance, lubricating the various components of the crimper in key grease point areas is crucial. See below for instructions: Grease Point 1 Place a thin layer of CrimpX oil (supplied with crimper), or a high-pressure molybdenum grease, on the surface of the cone insert (as shown in Figure 1). Grease Point 2 Before sliding the PC125-RCD press plate over the correct dies, place a thin layer of CrimpX oil (supplied with crimper), or a high-pressure molybdenum grease, on the entire area that the dies come in contact with (as shown in Figure 2). If the dies are sticking in the cone insert, continue to lubricate/grease as explained above in addition to lubricating each die finger individually (as shown in Figure 3). Please note, the die fingers must be lubricated at both positions that come in contact with the PC125-RCD pressure plate and the cone insert. Figure 1 Figure 2 Figure 3 If you have any questions, please contact your Continental Sales Representative. January 3, 2017 (06Continental Crimper Machine Lubrication Tech Tip)